# C5 CB400 board kernel cfg. Top-level so c5 build also gets these flips —
# all repair-direction (safer for both).

# Vendor DRM: c5_postblend_hw_disable trips UB → BRK #0x3e8 → panic during
# DRM probe. Disabling UBSAN_TRAP makes UB warn-only.
# CONFIG_UBSAN_TRAP is not set

# Vendor DRM: am_meson_drm_fbdev_init runs drm_fb_helper_initial_config before
# meson_vpu_reg_handle_register → rdma_ins[-1] OOB → NULL deref.
# CONFIG_AMLOGIC_DRM_EMULATE_FBDEV is not set

# clk-scmi.ko has no modalias; udev never auto-loads it. Built-in (=y) so SCMI
# clock provider is registered before any pinctrl/mmc/clk-v2 probe.
CONFIG_COMMON_CLK_SCMI=y

# RTL8211F PHY on BY401 ethmac_a: amlogic_realtek.ko's mdio: aliases never match
# because PHY uevent emits only `of:Nethernet-phyT(null)`. Module never auto-loads
# → end0 stays unbound → no link. Built-in (=y) so PHY driver is registered before
# stmmac probes the MDIO bus. Same pattern as CONFIG_COMMON_CLK_SCMI=y above.
CONFIG_AMLOGIC_REALTEK=m

CONFIG_RFKILL_INPUT=y
CONFIG_USB_SERIAL=y
CONFIG_USB_SERIAL_CH341=y
CONFIG_USB_SERIAL_CP210X=y
CONFIG_TMPFS_POSIX_ACL=y

#enable AMFC
CONFIG_AMLOGIC_AMFC=m
# if soc not define, it will use default AMFC_S7D
CONFIG_AMFC_C5=y
CONFIG_AMFC_BASE=0xFE092000