#config version info <char>
version=1

#cali config <short>
cali_config=0
cali_proofing=0

#frequency offset <char>
freq_offset=0
htemp_freq_offset=4

#cca ed detect mode
cca_ed_det=0

#p212 tssi offset cfg <char>

#wf2g spur remove enable cfg <char>
wf2g_spur_rmen=0
spur_freq=24478

#rf count<unsigned char>
rf_count=2

#scan report country ie <char>
country_ie_report=0

#tssi_ratio_limit =[on=1/off=0],[2g_ratio,],[5g_ratio]
wftx_tssi_ratio_limit=1,100,133
digital_code_gain_limit=1,0x0,0xff,0x0,0xff

#efuse value <int32>
#efuse_9=0x00ff0000
#efuse_a=0x756a0032
#efuse_b=0x79797e91
#efuse_c=0x837c796f
#efuse_d=0x00000000
#efuse_e=0x00000000

#key power <uint8>
#pwr_band2_11b_20M=18
#pwr_band2_11n_20M=17
#pwr_band2_11n_40M=17
#pwr_band5_5200=14
#pwr_band5_5300=14
#pwr_band5_5530_20M=15
#pwr_band5_5530_40M=14
#pwr_band5_5530_80M=14
#pwr_band5_5660=14
#pwr_band5_5780=14

#txt_shift_value for board gap 70~140
txt_shift_value_2442=100
txt_shift_value_5200=88
txt_shift_value_5300=90
txt_shift_value_5530=100
txt_shift_value_5660=110
txt_shift_value_5780=110

#config 2g channel bandwidth [0]:20/40Mhz [1]:20Mhz only
channel_2g_20Mhz_only=0
#scan abort when TP test
scan_abort_enable=1
scan_interval_thr=22

#wifi 2g/5g tx power table
wftx_pwrtbl_en=1
##0:11b(1,2) 1: 11b(5.5,11) 2:11a/g(6~12) 3:11a/g(18~36) 4:11a/g(48) 5:11a/g(54)
##6:11n(MCS0~2) 7:11n(MCS3~5) 8:11n(MCS6) 9:11n(MCS7) 10:11ac(MCS0~2)
##11:11ac(MCS3~5) 12:11ac(MCS6) 13:11ac(MCS7) 14:11ac(MCS8) 15:11ac(MCS9)
wf2g_20M_pwr_tbl=0x62,0x62,0x86,0x7A,0x5F,0x5F,0x86,0x69,0x5C,0x5C,0xdb,0xc8,0xa8,0x96,0x82,0x64
wf2g_40M_pwr_tbl=0x70,0x62,0x8B,0x7A,0x5F,0x5F,0x9C,0x79,0x6B,0x6B,0x7C,0x75,0x6C,0x66,0x5D,0x64
wf5g_20M_pwr_tbl=0x70,0x62,0x88,0x9B,0x7B,0x6c,0x85,0x90,0x80,0x72,0x82,0x94,0x74,0x72,0x5B,0x64
wf5g_40M_pwr_tbl=0x70,0x62,0x8C,0x9B,0x7B,0x7E,0x9C,0x9E,0x90,0x8D,0x98,0x98,0x7C,0x7D,0x64,0x64
wf5g_80M_pwr_tbl=0x70,0x62,0x8C,0x9B,0x7B,0x7E,0x9C,0x9E,0x90,0x8D,0x96,0x9D,0x8D,0x8B,0x63,0x64